INSTALLATION

BE SURE THE HEIGHT IS ADJUSTED TO YOUR CART BEFORE INSTALLATION

PARTS

1. Clear Heavy Duty Grade Vinyl Screen [X]
2. Two stabilizer bars [Y&Z]
3. Two sticky-back bolts [A&B] LOOSE
4. One “EYE” bolt mounted under lower bar at back [C]
5. One “EYE” bolt mounted under lower bar at back [D]
6. One 24″ Bungee [E]

ASSEMBLY

A. Stick Upper bar to roof with bolts [A&B]
B. Lift seat and connect “EYE” bolts [C&D] under & behind seat

TOOLS NEEDED

1. Tape measure
2. 9/32 wrench or hex bit
3. Scissors

  1. Use Nuts to attach the Bar to both Bolts [A&B]
  2. Peel both adhesive covers off on Sticky Back Bolts [A&B]
  3. Stick both Sticky Bolts [A&B] to the roof in the center (side to side) of the cart such that the back edge of the vinyl just touches the seat
  4. Attach Bungee [E] to EYE Bolt [D] at front of seat
  5. Lift seat and run Bungee [E] under it and attach to EYE Bolt [C]
    If Bungee is too loose, tie a knot (or more) in it to shorten it so that it provides a nice snug fit
  6. Replace seat